100/100
Fun Score · from 3 ratings
3
Ratings
37
On Location
Ranked #77 of all time · ranking score 78.3 · See the list
Ranked #77 of all time · ranking score 78.3 · See the list
The Old Chicago pinball machine, produced by Bally in 1976, is a classic electro-mechanical game designed by Greg Kmiec with artwork by Dave Christensen and John Youssi. This game, set in the prohibition-era, features a gangster theme and is known for its challenging gameplay and distinctive artwork.
1 want to play
Shoot the left spinner to increase saucer value; shoot the saucer to collect; repeat; shoot saucer-only when its value is 6K or higher.
Right
Very High; watch out for the fall-back of shots up the left side that don’t go all the way to the top.
The lit lane at the top; it switches sides with top rubber hits, so nudge accordingly for the left side or lag plunge it for the right side if you can get it to dribble in without triggering the right rubber’s switch [not that easy, it’s pretty sensitive].
This game is all about the bonus. Shoot the spinner on the left to advance it, collect it at the center saucer. If the ball is on the left flipper and you have little bonus, you can shoot the drops or saucer in the upper right for points. If the kickout from the saucer comes clean to the right flipper, though, either by cradle dead bounce or live catch, you can shoot the saucer as a ball transfer. Then shoot the left spinner. Once the saucer value is high enough, just repeat saucer shots as much as you can, using whichever technique [dead bounce, catch, trap] works best to set up a repeat shot. This is a great game for patience and for practicing dead bounces. Many bounces will end up dropping towards a flipper, and dead bouncing is most often the best way to get control. Most Old Chicagos play slow, too, other than when the ball is in the bumpers. Speaking of ball in the bumpers, if your bumpers are reasonably active, don’t worry overmuch about shaking the game while the ball is in them; it doesn’t drain through the lanes below them as often as you’d think unless the bumpers are weak.
via Bob's Guide
On the floor at 37 locations
Showing top 20 of 37 locations
Rubber ring sizes and movable adjustment posts
615 KB
Text edition without schematics
1.7 MB
Card numbers for 3-ball and 5-ball Replay and Extra Ball
141 KB
Slam switch gap and delay relay bulb
150 KB
Includes credit setting notes
262 KB
Dated 3-30-76, split over four pages with coil chart
342 KB
Dated 3-30-76, on one continuous oversized sheet
3.9 MB
